Lamp controlge ar-Part7 :Particularr equirementsf ord .c. s upplied
electronic ballasts for aircraft lighting
(IEC 61347-2-6:2000, ID T)

2005-01一18发布2005-08-01实施
中华人民共和国国家质量监督检验检疫总局
中国国家标准化管理委员会发布

GB 19510.7-2005/IEC 61347-2-6:2000

目次
前言······················································································，，··························⋯⋯ 皿
引言····· ······ “······ ····· ‘·‘······· ··‘··‘·······，，··，，，······ ···· ····‘· “ ·········，，··‘··⋯ ⋯ 4`
1 范围······················，·····················，··················· 、·································，·········⋯ ⋯ 1
2 规范性引用文件·，··············································-···············....·········...........···....⋯⋯ 1
3 定义····································，······，······················································，··········⋯ ⋯ 1
4 一般要求······································· ············，，·，-···········，·························· ·····⋯ ⋯ 1
5 试验说明···················· ······························，，·· ·········，，·.................................. I
6 分类····，······························，·························、·············································⋯⋯ 1
7 标志······················· ·······································，······················· ···········，·······⋯ ⋯ 1
7.1 强制性标志············-··································，······，································，，·······⋯⋯ 1
7.2 补充标志········ ·，················，，，···· ····························· ··········，，，·········⋯⋯ 1
S 防止意外接触带电部件的措施········，·····················，···················· 、、、······················⋯⋯ 2
9 接线端子···················、··················································································⋯⋯ 2
10 保护接地装置·······································································，···························⋯⋯ 2
11 防潮与绝缘··············，········································ ·············， ····························⋯ ⋯ 2
12 介电强度·· 、·····，··，，，········，···，，·，，，···········，，，，，··········，···，··· ······，，，··，······· 4·一2
13 绕组的耐热试验········，··················，，····················、·‘··········⋯，············.........····...⋯⋯ 2
14 脉冲电压··················，···········································，······································⋯⋯ 2
15 异常状态·························································」················，，·····，·····················⋯⋯ 3
16 故障状态···················· ··············· ··········，，··，···········，··································」···一3
17 结构·，···，···················， 、、··········，·················，····················，·······························⋯ ⋯ 3
18 爬电距离和电气间隙···，，···································，················...·········...........·....⋯ ⋯ 3
19 螺钉、载流部件和连接件··········································································..···....⋯⋯ 4
2。耐热、防火和耐漏电起痕·······················································...··⋯⋯，，，，.，，.........⋯⋯ 4
21 耐腐蚀··-··11111·，，··，，，，，····卜····，，，，，，二·· ...........................·，， ···，··，，，，，，······ ·一9
附录A(规范性附录) 确定导电部件是否是可能引起电击的带电部件的试验············，，·······⋯⋯ 6
附录B(规范性附录) 热保护式灯的控制装置的特殊要求·············································⋯⋯ 6
附录C(规范性附录) 带过热保护器的灯的电子控制装置的特殊要求·····························⋯⋯ 6
附录D(规范性附录) 热保护式灯的控制装置的加热试验要求········· -······················⋯⋯ 6
附录E(规范性附录) 不同于4 500的常数S在tw(绕组温度)试验中的应用····················⋯⋯ 6
附录F(规范性附录) 防对流风试验箱···················，·‘················，，··························⋯⋯ 6
附录G (规范性附录) 脉冲电压值的推导方法···························································⋯⋯ 6
附录H(规范性附录) 试验······································ ·······⋯⋯，，，········..⋯⋯，，，，.......⋯⋯ 7
图1 产生和施加短期脉冲的适用线路⋯⋯
图2 整流效应试验线路···，··············⋯⋯
表1 长期脉冲电压···············⋯⋯
表2 短期脉冲电压(10 Ks或更短)

GB 19510.7-2005/IEC 61347-2-6:2000

前      言

本部分的全部内容为强制性。
GB 19510《灯的控制装置》分为12个部分:
第1部分:一般要求和安全要求;
第2部分:启动装置(辉光启动器除外)的特殊要求;
— 第 3部分:钨丝灯用直流/交流电子降压转换器的特殊要求;
— 第 4部分:荧光灯用交流电子镇流器的特殊要求;
— 第 5部分:普通照明用直流电子镇流器的特殊要求;
— 第 6部分:公共交通运输工具照明用直流电子镇流器的特殊要求;
— 第 7部分:航空器照明用直流电子镇流器的特殊要求;
— 第 8部分:应急照明用直流电子镇流器的特殊要求;
— 第 9部分:荧光灯用镇流器的特殊要求;
— 第 10部分:放电灯(荧光灯除外)用镇流器的特殊要求;
— 第 11部分:高频冷启动管形放电灯(霓虹灯)用电子换流器和变频器的特殊要求;
— 第 12部分:与灯具联用的杂类电子线路的特殊要求
本 部 分 为GB 19510《灯的控制装置》的第7部分:航空器照明用直流电子镇流器的特殊要求;
本 部 分 应与GB 19510.1一起使用，它是在对GB 19510.1 的相应条款进行补充或修改之后制定而
成的
本 部 分 等同采用IEC 61347-2-6:2000《灯的控制装置第2-6部分:航空器照明用直流电子镇流器
的特殊要求》(英文版)。
本 部 分 等同翻译IEC 61347-2-6:20000
为 了 便 于使用，本部分做了下列编辑性修改:
a) "IE C 61347-2-6'，改为“本部分，',"IEC 61347-2-6号标准”一词改为“GB 19510.7";
b) 删 除IEC 61347-2-6的前言，修改了IEC 61347-2-6的引言;
c) 将 国际标准中的“(注:)”形式中的括号去除:
d) 用 小数点“.”代替作为小数点的“，”;
e) 对 于GB 19510.1 -2004引用的其他国际标准中有被等同采用为我国标准的，本部分用引用
我 国 的 这 些 国 家 标准或行业标准代替对应的国际标准，其余未有等同采用为我国标准的国际
标 准 ，在 本 部 分 中 均被直接引用(见本部分第2章)
GB 1 95 10.7 是灯的控制装置系列国家标准之一。下面列出了这些系列国家标准的预计结构及其
对应的国际标准，以及将代替的国家标准:
GB 1 95 10.1( (灯的控制装置第1部分:一般要求和安全要求》(IEC 61347-1);
GB 1 95 10.2《灯的控制装置第2部分:启动装置(辉光启动器除外)的特殊要求》(IEC6 1347-2-1);
GB 1 95 10.3 《灯的控制装置第3部分:钨丝灯用直流/交流电子降压转换器的特殊要求》
(IEC 61347-2-2);
GB 1 95 10.4《灯的控制装置第4部分:荧光灯用交流电子镇流器的特殊要求》(IEC 61347-2-3，代
替GB 15143-1994);
GB 19 51 0.5 《灯的控制装置第5部分:普通照明用直流电子镇流器的特殊要求》(IEC 61347-2-4);
GB 1 9 51 0.6《 灯的控制装置第6部分:公共交通运输工具照明用直流电子镇流器的特殊要求》
m
GB 19510.7-2005/IEC 61347-2-6:2000
(IEC 61347-2-5);
GB 1 95 10.7 《灯的控制装置第7部分:航空器照明用直流电子镇流器的特殊要求》(IEC 61347-2-6);
GB 1 95 10.8 《灯的控制装置第8部分:应急照明用直流电子镇流器的特殊要求》(IEC 61347-2-7);
GB 1 95 10.9 《灯的控制装置第9部分:荧光灯用镇流器的特殊要求》OE C 61347-2-8，代替
GB 2313- 1993);
GB 1 95 10.1 0《灯的控制装置第10部分:放电灯(荧光灯除外)用镇流器的特殊要求》(IEC 61347-
2-9，代替GB 14045-1993);
GB 1 95 10.1 1《灯的控制装置第11部分:高频冷启动管形放电灯(霓虹灯)用电子换流器和变频
器的特殊要求》(IEC 61347-2-10);
GB 1 95 10.1 2《灯的控制装置第12部分:与灯具联用的杂类电子线路的特殊要求)(IEC 61347-2
11),
本 部 分 的附录A,B,C,D,E,F,G,H为规范性附录
本 部 分 由中国轻工业联合会提出。
本部 分 由 全国照明电器标准化技术委员会(CSBTS/TC224)归口
本 部 分 的起草单位:国家电光源质量监督检验中心(上海)、北京电光源研究所。
本 部 分 起草人:陆荣树、裘继红、盛惠娟、俞安琪、杨小平、赵秀荣、全红、高杉楠。
本 部 分 为首次制定。
本站声明：登载此文出于传递更多信息之目的，其真实性未证实。转载请表明出处！
 

 下载全文:链接地址