Lampc ontrolgear-Part8 :Particularr equirementsf ord .c. s upplied
ele ct ron ic b all as ts f o re m er gen cyl ighting
(IEC 61347-2-7:2000,IDT)

GB 19510.8-2005/IEC 61347-2-7:2000

目次
前言
引言
1 范围
2 规范性引用文件
3 定义
4 一般要求
5 试验说明
6 分类
7 标志
8 防止意外接触带电部件的措施
9 接线端子
1。保护接地装置················，···········⋯⋯““”““’“““““““““““‘
H 防潮与绝缘·····、·······⋯⋯“·“”二’““ ‘’‘·““““’“““““”“‘’
12 介电强度·················-··················一“··············⋯⋯”’‘”’‘”
13 绕组的耐热试验·······，················⋯⋯，··...⋯⋯，...............⋯⋯
14 镇流器共电制的脉冲电压····，············································一
15 启动要求····················，····································⋯⋯“““·““
16 灯电流和光通量····，·········，····⋯⋯，，.·..⋯⋯，，.⋯⋯，二，，，.....⋯⋯
17 电源电流···，···································，··········，·················⋯⋯
18 任一引线(带预热阴极)的最大电流····································⋯⋯
19 灯工作电流的波形·······························...............⋯ ⋯
2。转换功能···································⋯⋯‘············⋯⋯””‘”””
21 充电装置···，··········，··········，·，·········，·····················，·······⋯⋯
22 过量放电的保护·················..........................⋯，.......⋯⋯，，
23 指示器···································································⋯⋯
24 遥控···1，········】····，··1····，····‘·····，-···1·····‘·，，，·····4····，一
25 温度循环试验和耐久性试验·······，····，·····，··························⋯⋯
26 极性变换···························，，··········，···········，···················一
27 故障条件···························，···········，，··········，········，，二‘’.““‘”’
28 结构·······································，·····，·····························⋯⋯
29 爬电距离和电气间隙，，····⋯⋯，··⋯，二，，....⋯⋯，，....⋯⋯，，.⋯，⋯⋯
3。螺钉、载流部件和连接件···，·····，·····，···········，···········一““”’“‘’
31 耐热、防火和耐漏电起痕
32 耐腐蚀·····，················、····，··、····· ············，，···11·‘”，，，，
附录A(规范性附录) 确定导电部件是否是可能引起电击的带电部件的试验··········⋯⋯
附录B(规范性附录) 热保护式灯的控制装置的特殊要求························，·········⋯⋯
附录C(规范性附录) 带过热保护器的灯的电子控制装置的特殊要求·············，······，·⋯
附录D(规范性附录) 热保护式灯的控制装置的加热试验要求····························⋯⋯
GB 19510.8-2005/IEC 61347-2-7:2000
0 八以O I OJ 月q ‘q ︹了
1 1 1 ，..
附录E(规范性附录) 不同于4 500的常数S在t,<绕组温度)试验中的应用二
附录F(规范性附录) 防对流风试验箱·，，，········· ·1·，，，，···，·······⋯ ⋯
附录G(规范性附录) 脉冲电压值的推导方法·····················，·············⋯⋯
附录H(规范性附录) 试验·············⋯⋯，...··.···..............⋯⋯，........⋯⋯
测量灯电流和光通量的适用线路
脉冲电压⋯⋯
高电阻和低电阻阴极灯的开路电压(阴极预热)
放电电压··················.··..···.⋯⋯，....⋯⋯
图表

 下载全文:链接地址